NetRobin
DISCONNECTED

Connection Status

cloud relay · local agent · Cisco AP sensor · RF stream
Cloud Relay
Not paired
Latency —
wss only — no local sockets
Local Agent
Offline
No agent paired
Seen —
Cisco AP Sensor
No sensor bound
Bind an agent sensor
Decoder —
RF Stream
Idle
Last frame —
0 frames · 0 KB
Link not established
No interruptions so far

Sensor Roster

up to 10 concurrent sensors

Sensors (0/10)

    Each sensor keeps its own source, band and link state. Up to 10 stream at once; the selected sensor below is the one the instrument views and the fields on this page act on.

    Source & Pairing

    selected sensor

    Cisco AP sensor → Windows Local Agent → outbound TLS to the cloud relay → this workstation. No inbound ports, no tunnels, and the AP credential never leaves the agent machine.

    Pairing

    Generate a pairing code, then type it into the agent's control panel on the Windows machine.

    AP address and NSI key are configured inside the agent on the Windows machine — this site never receives them.

    Radios

    Radios and bands are discovered automatically on the access point — nothing to choose here.

    Link disconnected

    Live Verification

    confirm the sweep is arriving
    CurrentAverage

    Get Live RF In Four Steps

    download → pair → configure locally → connect · agent v2.4.27
    1. 1Download the Windows AgentUnzip anywhere on the machine that can reach the access point and run INSTALL-WINDOWS.bat. No admin rights and no system-wide install are needed.
    2. 2Pair with a codeGenerate a pairing code here and type it into the agent control panel. The agent dials the cloud relay outbound over TLS — no inbound ports, no tunnel software.
    3. 3Configure the AP locallyAP address, NSI/spectrum key, radio and bands are entered in the agent on your machine. The key is stored protected by Windows DPAPI and never reaches this website.
    4. 4Connect and streamBind an agent sensor above and press Connect. Decoded sweeps, duty cycle, devices and RF events arrive over the paired session only.

    Full instructions, supported hardware and decoder limitations are on the Local Agent page.

    Diagnostics

    relay and agent log

    No relay activity yet.